LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Mechanical - 3.8L) >> Repair Instructions - On Vehicle >> Engine Oil Pressure Sensor and/or Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Engine Oil Pressure Sensor
    GM153592Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  1. Install the engine oil pressure sensor.

    Tighten:  Tighten the engine oil pressure sensor to 16 N.m (12 lb ft).

  2. Connect the engine oil pressure sensor electrical connector.
  3. Lower the vehicle.
  4. Fill the crankcase as necessary. Refer to Engine Oil and Oil Filter Replacement .
scientia non olet · About LEMON Manuals