LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Mechanical - 3.8L) >> Repair Instructions - On Vehicle >> Engine Mount Strut Bracket Replacement - Upper Radiator Support >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Mount Strut Bracket & Upper Radiator Support
    GM190494Courtesy of GENERAL MOTORS CORP.
  1. Position the engine mount strut bracket over the upper radiator support so the engine mount strut bracket and the engine mount strut are aligned. Align the engine mount strut bracket with the proper holes of the upper radiator support.
    2. NOTE: Refer to Fastener Notice .
  2. Install the 4 bolts through the engine mount strut bracket to the upper radiator support.

    Tighten:  Tighten the bolts to 28 N.m (21 lb ft).

    3. Fig 2: Identifying Engine Mount Strut
    GM97613Courtesy of GENERAL MOTORS CORP.
  3. Install the engine mount strut(s) to the engine mount strut bracket(s) at the upper radiator support. Refer to Engine Mount Strut Replacement - Left Side  and/or Engine Mount Strut Replacement - Right Side .
scientia non olet · About LEMON Manuals