LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Mechanical - 3.8L) >> Repair Instructions - On Vehicle >> Engine Mount Strut Bracket Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Left Engine Mount Strut Bracket & Bolts
    GM35814Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount strut bracket to the head.
    2. NOTE: Refer to Fastener Notice .
  2. Install the engine mount strut bracket bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    3. Fig 2: View Of Left Engine Mount Strut Bolt & Nut
    GM327466Courtesy of GENERAL MOTORS CORP.
  3. Install the engine mount strut to the left engine mount strut bracket. Refer to Engine Mount Strut Replacement - Left Side  and Engine Mount Strut Replacement - Right Side .
  4. Install the engine coolant temperature sensor. Refer to Engine Coolant Temperature Sensor Replacement .
  5. Fill the cooling system with engine coolant. Refer to Cooling System Draining and Filling (L26, LY7 GE 47716 Fill) or Cooling System Draining and Filling (L26 Static Fill) .
scientia non olet · About LEMON Manuals