LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Mechanical - 3.8L) >> Repair Instructions - On Vehicle >> Engine Front Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Motor Mount & Frame Nuts
    GM1212272Courtesy of GENERAL MOTORS CORP.
  1. Position the motor mount on the frame
  2. Use the jackstand to lower the motor mount bracket on to the motor mount.
    3. NOTE: Refer to Fastener Notice .
  3. Install the motor mount to frame bolts.

    Tighten:  Tighten the nuts to 47 N.m (35 lb ft).

    4. Fig 2: Identifying Engine Mount-To-Engine Mount Bracket Nuts
    GM43405Courtesy of GENERAL MOTORS CORP.
  4. Install the motor mount to motor mount bracket nuts.

    Tighten:  Tighten the nuts to 47 N.m (35 lb ft).

  5. Install the engine splash shield. Refer to Engine Splash Shield Replacement .
  6. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals