LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Mechanical - 3.8L) >> Repair Instructions - On Vehicle >> Engine Front Mount Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission. Refer to Transmission Replacement .
  2. Remove the drive belt. Refer to Drive Belt Replacement (L26) .
    3. IMPORTANT: Do not discharge the air conditioning system.
  3. Remove the A/C compressor from the engine. Refer to Compressor Replacement (L26) .
  4. Secure the compressor away from the bracket area.
  5. Remove the engine mount. Refer to Engine Front Mount Replacement .
  6. Remove the engine knock sensor shield and disconnect the sensor harness. Refer to Knock Sensor 2 Replacement .
    7. Fig 1: Identifying Left Engine Mount Bracket Bolts
    GM97800Courtesy of GENERAL MOTORS CORP.
  7. Remove the front engine mount bracket bolts from the engine.
    8. Fig 2: Identifying Right Engine Mount Bracket Bolts
    GM97804Courtesy of GENERAL MOTORS CORP.
  8. Remove the rear engine mount bracket bolts from the engine.
  9. Remove the engine mount bracket from the vehicle.
scientia non olet · About LEMON Manuals