LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Mechanical - 3.8L) >> Repair Instructions - On Vehicle >> Engine Front Mount Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the engine mount bracket to the engine.
  2. Connect the knock sensor harness connector and install the shield. Refer to Knock Sensor 2 Replacement .
    3. Fig 1: Identifying Right Engine Mount Bracket Bolts
    GM97804Courtesy of GENERAL MOTORS CORP.
  3. Install the rear engine mount bracket bolts to the engine. Hand tighten the bolts at this time.
    4. Fig 2: Identifying Left Engine Mount Bracket Bolts
    GM97800Courtesy of GENERAL MOTORS CORP.
  4. Install the front engine mount bracket bolts to the engine. Hand tighten the bolts at this time.
    5. NOTE: Refer to Fastener Notice .
  5. Install the engine mount bracket bolts.

    Tighten:  Tighten the bolts to 102 N.m (75 lb ft).

  6. Install the engine mount. Refer to Engine Front Mount Replacement .
  7. Install the A/C compressor to the engine. Refer to Compressor Replacement (L26) .
  8. Install the drive belt. Refer to Drive Belt Replacement (L26) .
  9. Install the transmission. Refer to Transmission Replacement .
scientia non olet · About LEMON Manuals