LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Mechanical - 3.8L) >> Repair Instructions - On Vehicle >> Drive Belt Tensioner Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (L26) .
  2. Drain the cooling system. Refer to Cooling System Draining and Filling (L26 Static Fill) .
  3. Remove the coolant recovery reservoir.
  4. Remove the drive belt. Refer to Drive Belt Replacement (L26) .
  5. Remove the generator. Refer to Generator Replacement (L26) .
  6. Remove the heater hose adapters with the heater hoses from the drive belt tensioner. Refer to Heater Inlet Hose Replacement (L26) or Heater Outlet Hose Replacement (L26) .
    7. Fig 1: View Of Drive Belt Tensioner
    GM326960Courtesy of GENERAL MOTORS CORP.
  7. Remove the drive belt tensioner bolts.
  8. Remove the drive belt tensioner.
  9. If replacing the drive belt tensioner, remove the thermostat bypass upper and lower pipe assemblies.
scientia non olet · About LEMON Manuals