LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Mechanical - 3.8L) >> Repair Instructions - On Vehicle >> Crankshaft Front Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
    2. Fig 1: Identifying Crankshaft Front Oil Seal
    GM153586Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Be careful not to damage the crankshaft.
  2. Pry out the crankshaft front oil seal with a flat bladed tool such as a large screwdriver. Use care to avoid damaging the crankshaft front oil seal bore or the crankshaft front oil seal contact surfaces.
  3. Inspect the crankshaft balancer and engine front cover for scratches.
scientia non olet · About LEMON Manuals