LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Mechanical - 3.8L) >> Repair Instructions - On Vehicle >> Crankshaft Front Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Crankshaft Front Oil Seal & J 35354-A
    GM153590Courtesy of GENERAL MOTORS CORP.
  1. Install the crankshaft front oil seal in the engine front cover using the J 35354-A  . See Special Tools .
  2. Tighten the bolt until the crankshaft front oil seal is seated in the engine front cover.
  3. Remove the J 35354-A  . See Special Tools .
  4. Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
  5. Inspect for leaks.
  6. Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn .
scientia non olet · About LEMON Manuals