LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Mechanical - 3.8L) >> Repair Instructions - Off Vehicle >> Oil Pump Suction Pipe and Screen Assembly Installation

Oil Pump Suction Pipe and Screen Assembly Installation

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pump Pipe & Screen Assembly
    GM26202Courtesy of GENERAL MOTORS CORP.
  1. Install the oil pump pipe and screen assembly gasket.
    2. IMPORTANT: The oil pan gasket must be installed before the oil pump pipe and screen assembly.
  2. Install the oil pan gasket.
  3. Install the oil pump pipe and screen assembly.
    4. NOTE: Refer to FASTENER NOTICE .
  4. Install the oil pump pipe and screen assembly bolts.

    Tighten:  Tighten the bolts to 15 N.m (11 lb ft).

scientia non olet · About LEMON Manuals