LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Mechanical - 3.8L) >> Repair Instructions - Off Vehicle >> Lower Intake Manifold Removal (L26)

Lower Intake Manifold Removal (L26)

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Generator Brace Bracket
    GM1335973Courtesy of GENERAL MOTORS CORP.
  1. Remove the generator brace bracket bolts (569, 570).
  2. Remove the generator brace bracket (571).
    3. Fig 2: Identifying Lower Intake Manifold Bolts
    GM154533Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Bolts which fasten the lower intake manifold to the cylinder head are accessible only after the upper intake is removed. The bolts are located in the right front and left rear corners of the lower intake manifold. Remove the upper intake manifold to service the lower intake.
  3. Remove the lower intake manifold bolts.
  4. Remove the lower intake manifold.
  5. Remove the lower intake manifold gasket.
scientia non olet · About LEMON Manuals