Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Engine Flywheel Bolts

Courtesy of GENERAL MOTORS CORP.

Install the flywheel.

Fig 2: View Of Flywheel & Flywheel Holder (J 37096)

Courtesy of GENERAL MOTORS CORP.

Use the J 37096 to secure the flywheel in order to prevent the crankshaft from rotating. See Special Tools .

NOTE: Refer to FASTENER NOTICE .

Install the new flywheel bolts.
Tighten: Tighten the bolts to 15 N.m (11 lb ft). Use the J 45059 to tighten the bolts an additional 50 degrees.