LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Mechanical - 3.8L) >> Repair Instructions - Off Vehicle >> Camshaft Bearing Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Camshaft Bearings
    GM683961Courtesy of GENERAL MOTORS CORP.
  1. Select the camshaft bearings.
    2. Fig 2: View Of Camshaft Bearing Service Set
    GM622704Courtesy of GENERAL MOTORS CORP.
  2. Use the following procedure to install the camshaft bearings:
    1. Assemble J 33049  according to the manufacturer's instructions. See Special Tools .
    2. Place the bearing on the tool.
      3. NOTE: Severe engine damage may result if the oil holes are not correctly aligned.
    3. Index the bearing oil holes with the engine block oil passages.
scientia non olet · About LEMON Manuals