LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Mechanical - 3.8L) >> Repair Instructions - Off Vehicle >> Balance Shaft Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Using J 21465-13 & J 36996 To Install Balance Shaft Into Engine Block
    GM566836Courtesy of GENERAL MOTORS CORP.
  1. Use J 21465-13  and J 36996  to install the balance shaft into the engine block. See Special Tools .
    2. Fig 2: View Of Balance Shaft Retainer
    GM42237Courtesy of GENERAL MOTORS CORP.
  2. Install the balance shaft retainer.
    3. NOTE: Refer to FASTENER NOTICE .
  3. Install the balance shaft retainer bolts.

    Tighten:  Tighten the balance shaft retainer bolts to 30 N.m (22 lb ft).

    4. Fig 3: Locating Balance Shaft Driven Gear & Bolt
    GM154521Courtesy of GENERAL MOTORS CORP.
  4. Install the balance shaft driven gear.
    5. NOTE: Refer to Special Fastener Notice .
  5. Install the balance shaft driven gear bolt.

    Tighten:  Tighten the balance shaft driven gear bolt to 22 N.m (16 lb ft). Use J 45059  to tighten the bolt an additional 70 degrees.

    6. Fig 4: Measuring Balance Shaft End Play
    GM38470Courtesy of GENERAL MOTORS CORP.
  6. Using J 8001  measure the balance shaft end play. End play must not exceed 0.028 mm (0.008 in).
    7. Fig 5: Measuring Balance Shaft Radial Play
    GM38472Courtesy of GENERAL MOTORS CORP.
  7. Using J 8001  measure the balance shaft radial play at the rear. Radial play must be between 0.0127-0.119 mm (0.0005-0.0047 in).
  8. Install the balance shaft drive gear.
  9. Install the camshaft sprocket.
  10. Turn the camshaft so the timing mark on the camshaft sprocket is straight down.
  11. Remove the camshaft sprocket and balance shaft drive gear.
  12. Turn the balance shaft so the timing mark on the balance shaft driven gear points straight down.
  13. Partially install the balance shaft drive gear so the gear teeth are not engaged.
  14. Align the marks on the balance shaft driven gear and the balance shaft drive gear. Do this by turning the balance shaft.
  15. Once marks are aligned, fully seat balance shaft drive gear and engage gear teeth.
  16. Turn the crankshaft so the number one piston is at top dead center.
  17. Install the timing chain and camshaft spocket.
    18. Fig 6: Measuring Balance Shaft Gear Lash
    GM38477Courtesy of GENERAL MOTORS CORP.
  18. Using J 8001  measure the gear lash at four places. Measure every quarter turn. Gear lash must be between 0.050-0.127 mm (0.002-0.005 in).
scientia non olet · About LEMON Manuals