LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Mechanical - 3.8L) >> Repair Instructions - Off Vehicle >> Balance Shaft Bearing and/or Bushing Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Balance Shaft Bushing Using J 36995
    GM36707Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The J 36995  installs the balance shaft bushing to the correct depth. See Special Tools . The balance shaft bushing is properly installed when J 36995  fully contacts the balance shaft bore or the engine block/transaxle mounting flange. See Special Tools .
  1. Dip the balance shaft bushing in clean engine oil.
  2. Use the balance shaft bushing installers to install the balance shaft bushing.
  3. Remove J 36995  . See Special Tools .
    4. Fig 2: Using J 21465-13 & J 36995 To Install Balance Shaft Bearing Into Engine Block
    GM622251Courtesy of GENERAL MOTORS CORP.
  4. Dip the balance shaft bearing into clean engine oil.
  5. Use J 21465-13  and J 36995  to install the balance shaft bearing into the engine block. See Special Tools .
scientia non olet · About LEMON Manuals