LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Battery, Charging System And Starting System) >> Repair Instructions >> Starter Shield Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (L26)  or Battery Negative Cable Disconnection and Connection (LY7)  or Battery Negative Cable Disconnection and Connection (LS4) .
    2. Fig 1: Aligning Starter Heat Shield To Starter Motor & Brackets
    GM772392Courtesy of GENERAL MOTORS CORP.
  2. Remove the fasteners securing the starter heat shield to the starter.
  3. Remove the starter heat shield.
    4. Fig 2: View Of Starter Heat Shield Mounting Bracket Retaining Nut
    GM772393Courtesy of GENERAL MOTORS CORP.
  4. Remove the nut securing the starter heat shield mounting bracket to the starter.
  5. Remove the starter heat shield mounting bracket.
    6. Fig 3: Locating Starter Heat Shield Mounting Bracket To Engine Block Retaining Nut
    GM847390Courtesy of GENERAL MOTORS CORP.
  6. Remove the nut securing the starter heat shield mounting bracket to the engine block.
  7. Remove the starter heat shield mounting bracket.
scientia non olet · About LEMON Manuals