LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Battery, Charging System And Starting System) >> Diagnostic Information and Procedures >> DTC C0896 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the EBCM.
  2. Test for less than 1.0 ohm of resistance between the ground circuits X1 terminals 12 and 15 and ground.
    • If greater than the specified range, test the ground circuits for an open/high resistance.
  3. Ignition ON, measure between the Ignition Voltage circuit X1 terminal 8 and ground. The readings should not differ by more than 2 volts than the battery terminal voltage.
    • If less than the specified range, test the Ignition Voltage circuit for a short to ground or an open/high resistance.
  4. If the circuit tests normal, replace the EBCM.
scientia non olet · About LEMON Manuals