LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Frame And Underbody) >> Repair Instructions >> Rear Frame Cushion or Insulator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Bolts From Rear Frame Of Body
    GM1208437Courtesy of GENERAL MOTORS CORP.
  1. Apply a thin coat of rubber lubricant GM P/N 01051717 (Canadian P/N 12345884) or equivalent to the inside surface of lower insulator and to top surface of upper insulator.
  2. Install the upper and lower insulators to the rear of the frame as a set.
  3. Install the frame. Refer to Frame Replacement .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals