LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Frame And Underbody) >> Repair Instructions >> Front Frame Cushion or Insulator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the front frame insulator opening.
  2. Apply a thin coat of rubber lubricant GM P/N 01051717 (Canadian P/N 12345884) or equivalent to the inside of the front frame insulator opening and to the front frame insulator.
    3. Fig 1: Aligning The Front Frame Insulator
    GM777205Courtesy of GENERAL MOTORS CORP.
  3. Align the front frame insulator to the opening with the alignment tabs facing to the front.
  4. Using the J 45296  , or equivalent install the insulator to the front frame. See Special Tools .
    5. Fig 2: View Of Front Frame Bolts And Retainers
    GM319188Courtesy of GENERAL MOTORS CORP.
  5. Install the frame front upper insulators.
  6. Raise the front of the frame.
    7. NOTE: Refer to Fastener Notice .
  7. Install the front frame bolts and retainers.

    Tighten:  Tighten the front bolts to 145 N.m (107 lb ft).

  8. Remove the jackstand.
  9. Connect the steering intermediate shaft. Refer to Intermediate Steering Shaft Replacement .
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals