LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Door Lock Systems & Door Handles) >> Repair Instructions >> Rear Compartment Lid Latch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Rear Compartment Lid Latch & Fasteners
    GM749299Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Position the rear compartment lid latch to the alignment marks on the rear compartment lid.
  2. Install the rear compartment lid latch to rear compartment lid nuts.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  3. Connect the electrical connectors to the rear compartment lid latch.
  4. Connect the lock cylinder actuator cable to the lock cylinder.
  5. Install rear compartment lid carpet. Refer to Rear Compartment Lid Inner Panel Trim Replacement .
  6. Close the rear compartment.