LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Door Lock Systems & Door Handles) >> Repair Instructions >> Door Handle Rod Adjustment - Rear Outside >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: The outside handles have adjustable outside handle lock rods. This allows for adjustment of the amount of travel needed in order to operate the outside handle.
    When servicing a vehicle with adjustable outside handle lock rods, remove all free play between the outside handle and the lock. Also, do not operate the outside handle before these connections are made.
  1. Remove the rear door trim pad. Refer to Rear Side Door Trim Panel Replacement .
  2. Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .

    The water deflector does not need to be completely removed.

  3. Raise the window to the full upright position.
  4. Fig 1: View Of Handle Rod To Lock Clip
    GM1350838Courtesy of GENERAL MOTORS CORP.
  5. Open the outside handle rod to lock clip located on the door lock.
  6. Adjust the rod as needed.
  7. Close the clip cover over the outside handle rod.