Removal Procedure
WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Apply masking tape to the outer applique and frame.
- Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
- Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
- Remove the rear door window inner belt sealing strip. Refer to Rear Door Window Belt Inner Sealing Strip Replacement .
- Lower the window far enough in order to gain access through the inner panel, unsnap the window guide retainer from the window.
- Push inward on the window guide retainer clip locks, lift upward on the window until released from the retaining clip.
- Lower the window regulator to the full down position.
- Remove the window from the door.
NOTE:
Refer to PAINT DAMAGE NOTICE
.