LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Fixed & MOVEABLE Window Systems) >> Repair Instructions >> Rear Side Door Window Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Window Guide
    GM1363625Courtesy of GENERAL MOTORS CORP.
  1. Position the window in between the inner and the outer panels.
    1. Point the lower front corner of the rear door window down.
    2. Pass the rear door window through the belt opening.
    3. Align the edges of the window with the rear door window weatherstrip.
    4. Ensure that both sealing lips on the rear door outer belt sealing strip are not rolled over and pointing downward.

      If this condition is present, the rear door window will not raise properly.

  2. Raise the window regulator to the middle position.
  3. Install the rearward window into the window guide retainer, snap the window into the window regulator.
  4. Remove the masking tape.
  5. Inspect the window for proper operation.
  6. Install the rear door window inner belt sealing strip. Refer to Rear Door Window Belt Inner Sealing Strip Replacement .
  7. Install the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
  8. Install the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals