LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Fixed & MOVEABLE Window Systems) >> Repair Instructions >> Rear Side Door Window Regulator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
  2. Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
    3. NOTE: Refer to PAINT DAMAGE NOTICE .
    Fig 1: View Of Window Guide
    GM1363625Courtesy of GENERAL MOTORS CORP.
  3. Raise the window far enough in order to gain access through the inner door panel to the window guide retainer clips.
  4. Push inward on the window guide retainer clip locks, lift upward on the window until released from the retaining clip.
  5. Raise the window to the full up position and tape in place.
  6. Disconnect the electrical connector from the power window motor.
    7. Fig 2: View Of Window Regulator
    GM1363645Courtesy of GENERAL MOTORS CORP.
  7. Loosen the bolt to the window regulator motor (2, 3, 4).
  8. Lift the motor free of the retaining slot.
  9. Remove the window regulator and motor from the door.
  10. Remove the power window motor from the window regulator. Refer to Rear Side Door Window Regulator Motor Replacement .
scientia non olet · About LEMON Manuals