LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Fixed & MOVEABLE Window Systems) >> Repair Instructions >> Rear Side Door Window Regulator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power window motor to the window regulator. Refer to Rear Side Door Window Regulator Motor Replacement .
    2. Fig 1: View Of Window Regulator
    GM1363645Courtesy of GENERAL MOTORS CORP.
  2. Install the bolts (2, 3, 4) to the window regulator and motor.
  3. Position the window regulator and motor into the locating slots of the inner door panel.
    4. NOTE: Refer to FASTENER NOTICE .
  4. Install the window regulator and motor bolts to the door.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  5. Connect the electrical connector to the power window motor.
  6. Remove the masking tape.
    7. Fig 2: View Of Window Guide
    GM1363625Courtesy of GENERAL MOTORS CORP.
  7. Lower the window far enough in order to gain access through the inner door panel to the window guide retainer clips.
  8. Inspect the window for proper operation and programming. Refer to Window Regulator Motor Programming and Setup .
  9. Install the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
  10. Install the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals