LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Fixed & MOVEABLE Window Systems) >> Repair Instructions >> Rear Side Door Window Channel Retainer Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Rear Door Window Channel Retainer Bolts & Rivets
    GM1363723Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to PAINT DAMAGE NOTICE .
  1. Remove the rear door frame applique. Refer to Rear Door Frame Applique Replacement .
  2. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
  3. Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
  4. Position the window to the full down position.
  5. Remove the rear door inner belt sealing strip. Refer to Rear Door Window Belt Inner Sealing Strip Replacement .
  6. Remove the rear door outer belt sealing strip. Refer to Rear Door Window Belt Outer Sealing Strip Replacement .
  7. Remove the rear door window weatherstrip. Refer to Rear Side Door Window Weatherstrip Replacement .
  8. Drill out the 4 mm (5/32 in) rivets (1) along the inside edge of the window channel retainer (2).
  9. Remove the bolt (3) from the corner of the window channel retainer (2).
  10. Remove the window channel retainer from the door.
scientia non olet · About LEMON Manuals