LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Fixed & MOVEABLE Window Systems) >> Repair Instructions >> Rear Side Door Window Adjustment >> Adjustment Procedure

Adjustment Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Window Regulator
    GM1363645Courtesy of GENERAL MOTORS CORP.
  1. Inspect for the following conditions before making adjustments:
    • Using a flat-bladed tool, straighten the run channel lip by pulling it out to its correct position.
    • Use a flat-bladed tool to push the run channel rearward to seat it in the door frame.
    • Inspect the window guide channel to window bolts to ensure that they are in the proper slots and the window is not tilted forward.
    • Inspect the window to be straight up and down position.
    • Loosen the bolts that attach the window regulator (1) to the inner door panel, in the specified sequence (2, 3, 4).
    2. NOTE: Refer to Fastener Notice .
  2. Loosen the bolts that attach the window regulator (1) to the inner door panel in the specified sequence (2, 3, 4).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Inspect the window for proper operation.
  4. Install the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
  5. Install the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals