LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Fixed & MOVEABLE Window Systems) >> Repair Instructions >> Rear Door Window Belt Inner Sealing Strip Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Sealing Strip - Rear Door Window Belt Inner
    GM1362848Courtesy of GENERAL MOTORS CORP.
  1. Position the window belt inner sealing strip to the door flange.
  2. Engage each end of the window belt inner sealing strip by pressing firmly onto the front and the rear ends of the pinch-weld flange.
    3. IMPORTANT:
    • Ensure the front end of the window inner belt sealing strip is inserted into the gap formed by the weatherstrip and the door inner panel.
    • Ensure the rear end of the window inner belt sealing strip is flush to the rear leg of the weatherstrip.
    • Ensure the rear end of the window inner belt sealing strip does not interfere with the path of the window.
  3. Use hand pressure in order to firmly seat the rear door window inner belt sealing strip on the pinch-weld flange.
  4. Inspect the door for proper operation.
  5. Install the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals