LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Fixed & MOVEABLE Window Systems) >> Repair Instructions >> Front Side Door Window Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Power Window Motor Electrical Connector
    GM1362843Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to PAINT DAMAGE NOTICE .
  1. Apply masking tape to the outer applique and frame.
  2. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
  3. Remove the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
  4. Remove the front door inner window belt sealing strip. Refer to Front Side Door Window Belt Inner Sealing Strip Replacement .
  5. Lower the window far enough in order to gain access through the inner panel, unsnap the window guide retainer from the window.
  6. Push inward on the window guide retainer clip locks, lift upward on the window until released from the retaining clip.
  7. Lower the window regulator to the full down position.
  8. Remove the window from the door.
scientia non olet · About LEMON Manuals