LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Fixed & MOVEABLE Window Systems) >> Repair Instructions >> Front Side Door Window Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Power Window Motor Electrical Connector
    GM1362843Courtesy of GENERAL MOTORS CORP.
  1. Position the window in between the inner and the outer panels.
    1. Point the lower front corner of the front door window down.
    2. Pass the front door window through the belt opening.
    3. Align the edges of the window with the door window weatherstrip.
    4. Ensure that both sealing lips on the front door outer belt sealing strip are not rolled over and pointing downward.

      If this condition is present, the window will not raise properly.

  2. Raise the window regulator to the middle position.
  3. Install the rearward window to the guide retainer, snap the window into the window regulator.
  4. Remove the masking tape.
  5. Inspect the window for proper operation.
  6. Install the front door inner belt sealing strip. Refer to Front Side Door Window Belt Inner Sealing Strip Replacement .
  7. Install the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
  8. Install the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals