LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Fixed & MOVEABLE Window Systems) >> Repair Instructions >> Front Side Door Window Regulator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power window motor to the window regulator. Refer to Front Side Door Window Regulator Motor Replacement .
    2. Fig 1: View Of Window Regulator
    GM1362845Courtesy of GENERAL MOTORS CORP.
  2. Install the window regulator and motor through the access opening in the inner door panel.
  3. Install the nuts (2, 4) to the window regulator studs.
  4. Install the window regulator motor bolts (3).
    5. NOTE: Refer to FASTENER NOTICE .
  5. Tighten the window regulator bolt and nuts to the door.

    Tighten:  Tighten the bolt and nuts to 10 N.m (89 lb in).

    6. Fig 2: Identifying Power Window Motor Electrical Connector
    GM1362843Courtesy of GENERAL MOTORS CORP.
  6. Connect the electrical connector to the power window motor and push in on the tab to lock in place.
  7. Remove the masking tape.
  8. Lower the window far enough in order to gain access through the inner panel to the window guide retainer to snap the window into the retainer.
  9. Inspect the window for proper operation and programming. Refer to Window Regulator Motor Programming and Setup .
  10. Install the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
  11. Install the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals