LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Fixed & MOVEABLE Window Systems) >> Repair Instructions >> Front Side Door Window Channel Retainer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Front Door Window Channel Retainer Bolts & Rivets
    GM1362822Courtesy of GENERAL MOTORS CORP.
  1. Install the window channel retainer to the door.
  2. Install the new 4 mm (5/32 in) rivets (1) along the inside edge of the window channel retainer.
  3. Install the bolt (3) to the window channel retainer (2).
    NOTE: Refer to FASTENER NOTICE .

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

  4. Install the front door window weatherstrip. Refer to Front Side Door Window Weatherstrip Replacement .

    Install the front door window weatherstrip by working it around the door frame. Ensure that the weatherstrip is fully seated into the window channel retainer.

  5. Inspect the window for proper operation.
  6. Install the front door frame applique. Refer to Front Door Frame Applique Replacement .
  7. Install the front door inner window belt sealing strip. Refer to Front Side Door Window Belt Inner Sealing Strip Replacement .
  8. Install the outside mirror. Refer to Power Mirror Replacement .
  9. Install the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
  10. Install the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals