LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Fixed & MOVEABLE Window Systems) >> Repair Instructions >> Front Side Door Window Adjustment >> Adjustment Procedure

Adjustment Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect for the following conditions before making adjustments.
    • Using a flat-bladed tool, straighten the run channel lip by pulling it out to its correct position.
    • Use a flat-bladed tool to push the run channel rearward to seat it in the door frame.
    • Inspect the window guide retainer to window for the proper alignment to the slots in the window.
    • Inspect the window to be straight up and down position.
      • Fig 1: View Of Window Regulator
      GM1362845Courtesy of GENERAL MOTORS CORP.
    • Loosen the bolts that attach the window regulator (1) to the inner door panel, in the specified sequence (2, 3, 4).
    2. NOTE: Refer to FASTENER NOTICE .
  2. Tighten the bolts that attach the window regulator (1) to the inner door panel in the specified sequence (2, 3, 4).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Inspect the window for proper operation.
  4. Install the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
  5. Install the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals