LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Mirror Systems) >> Repair Instructions >> Inside Rearview Mirror Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rearview Mirror
    GM330783Courtesy of GENERAL MOTORS CORP.
  1. Position the center bottom of the mirror mount against the windshield at the top of the support button.
  2. Slide the base of the mirror onto the button.
  3. NOTE: Refer to Fastener Notice .
  4. Make sure the mirror is firmly seated on the windshield button by pushing down on the base of the mirror.

    Tighten:  Tighten the screw to 1.8 N.m (16 lb in) in order to secure the mirror base to the button.

  5. Fig 2: Identifying Rearview Mirror Electrical Connector
    GM311618Courtesy of GENERAL MOTORS CORP.
  6. Connect the electrical connector (3) to the back of the mirror.
  7. Install the wire harness cover.
  8. Reposition the mirror.