LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Control System & Fuel System - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Spark Plug Wire Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Spark Plug Wires At Ignition Coils
    GM194220Courtesy of GENERAL MOTORS CORP.
  1. Position the spark plug wires to the engine.
  2. Install the spark plug wire retaining clips from the rear, front and top of the engine.
  3. Install the spark plug wires to the ignition coil in the proper position.
    4. Fig 2: Locating Spark Plug Wires & Identifying Cylinders 1/3/5
    GM194231Courtesy of GENERAL MOTORS CORP.
  4. Install the spark plug wires (1, 3, 5) to the spark plugs in the proper position at the front of the engine.
    5. Fig 3: Locating Spark Plug Wires & Identifying Cylinders 2/4/6
    GM194244Courtesy of GENERAL MOTORS CORP.
  5. Install the spark plug wires (2, 4, 6) to the spark plugs in the proper position at the rear of the engine.
  6. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals