LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Control System & Fuel System - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Mass Airflow Sensor/Intake Air Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying MAF/IAT Sensor
    GM1208107Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
    2. IMPORTANT: The intake air temperature (IAT) sensor and the mass air flow (MAF) sensor are combined as one sensor.
  2. Disconnect the MAF/IAT sensor electrical connector (2).
  3. Loosen the air cleaner intake duct clamps.
  4. Remove the air cleaner intake duct from the air cleaner housing cover and the throttle body assembly.
  5. Remove the MAF/IAT sensor from the air cleaner intake duct.
scientia non olet · About LEMON Manuals