LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Control System & Fuel System - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
  2. Disconnect the MAP sensor electrical connector.
    3. Fig 1: View Of MAP Sensor
    GM12346Courtesy of GENERAL MOTORS CORP.
  3. Carefully release the locking tabs holding the MAP (1) sensor to the PCV valve cover (2) just enough to remove the MAP sensor.
  4. Pull the MAP sensor straight out of PCV valve cover.
scientia non olet · About LEMON Manuals