LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Control System & Fuel System - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of MAP Sensor
    GM12346Courtesy of GENERAL MOTORS CORP.
  1. Ensure that the seal is installed on the MAP sensor and that the seal is not damaged.
  2. Position and install the MAP sensor (1) to the PCV valve cover (2). Ensure that the locking tabs engage to hold the MAP sensor to the PCV valve cover.
  3. Connect the MAP sensor electrical connector.
  4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals