LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Control System & Fuel System - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Strainer Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Always maintain cleanliness when servicing fuel system components.
    Fig 1: Identifying Fuel Sender Assembly
    GM50611Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
  2. Note the strainer (3) position for future reference.
    3. Fig 2: Prying Strainer Ferrule Off Reservoir
    GM54511Courtesy of GENERAL MOTORS CORP.
  3. Support the reservoir with one hand. Grasp the strainer with the other hand.
  4. Use a screwdriver to pry the strainer ferrule off the reservoir.
  5. Discard the strainer.
scientia non olet · About LEMON Manuals