LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Control System & Fuel System - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Exhaust Gas Recirculation Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EGR Valve
    GM911033Courtesy of GENERAL MOTORS CORP.
  1. Install a new EGR valve gasket (3).
  2. Install the EGR valve (2).
    3. NOTE: Refer to Fastener Notice .
  3. Install the EGR valve nuts (1).

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

  4. Connect the EGR valve electrical connector.
scientia non olet · About LEMON Manuals