LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Control System & Fuel System - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Chassis/Canister >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: View Of Fuel Filter & Pipes
    GM699549Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the evaporative emission (EVAP) purge pipe connector at the fuel filter area. Refer to Plastic Collar Quick Connect Fitting Service .
    3. Fig 2: Locating EVAP & Fuel Tank Components
    GM699561Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the EVAP purge pipe (8) from the EVAP canister (1). Refer to Plastic Collar Quick Connect Fitting Service .
  4. Remove the EVAP purge pipe (8).
scientia non olet · About LEMON Manuals