LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Control System & Fuel System - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating EVAP Vent Valve & Components
    GM698627Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the evaporative emission (EVAP) vent valve electrical connector (1).
  3. Remove the EVAP vent valve bracket bolt.
  4. Remove the vent hose (4) from the EVAP vent valve.
  5. Remove the EVAP vent valve from the bracket (2).
scientia non olet · About LEMON Manuals