LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Control System & Fuel System - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating EVAP Vent Valve & Components
    GM698627Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP vent valve to the bracket (2).
  2. Install the vent hose (4) to the EVAP vent valve.
  3. Install the EVAP vent valve and the bracket.
    4. NOTE: Refer to FASTENER NOTICE .
  4. Install the EVAP vent valve bracket bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  5. Connect the EVAP vent valve electrical connector (1).
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals