LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Control System & Fuel System - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Female Connector & Fuel Rail Pipe
    GM910914Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The evaporative emission (EVAP) purge valve is located on the upper intake manifold.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
  2. Disconnect the EVAP canister purge valve purge pipe (2).
  3. Disconnect the EVAP canister purge valve electrical connector.
    4. Fig 2: Identifying Throttle Body Assembly (L26)
    GM911046Courtesy of GENERAL MOTORS CORP.
  4. Remove the EVAP purge valve bolt (2).
  5. Remove the EVAP purge valve (3).
scientia non olet · About LEMON Manuals