LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Control System & Fuel System - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Throttle Body Assembly (L26)
    GM911046Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP purge valve (3).
    2. NOTE: Refer to Fastener Notice .
  2. Install the EVAP purge valve bolt (2).

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

  3. Connect the EVAP canister purge valve electrical connector.
    4. Fig 2: Identifying Female Connector & Fuel Rail Pipe
    GM910914Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP canister purge valve purge pipe (2).
  5. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals