LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Control System & Fuel System - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Element Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement .
    2. Fig 1: Identifying MAF/IAT Sensor
    GM1208107Courtesy of GENERAL MOTORS CORP.
  2. Unclip the retaining fasteners (4) on the air cleaner cover.
  3. Remove the air cleaner cover.
    4. Fig 2: View Of Air Cleaner Element
    GM1207827Courtesy of GENERAL MOTORS CORP.
  4. Remove the air cleaner element (1) from the air cleaner housing (2).
scientia non olet · About LEMON Manuals