Throttle Body Assembly
WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
The throttle assembly contains the following components:
- The throttle blade
- The throttle actuator motor
- The throttle position (TP) sensor 1 and 2
- The throttle actuator control (TAC) module
The throttle body functions similar to a conventional throttle body with the following exceptions:
- There is no longer an idle air control (IAC) motor and associated air passages.
- An electric motor opens and closes the throttle valve.
- The TAC module is located within the throttle body assembly.
- The throttle blade is spring loaded in both directions and the default position is slightly open.
- There are 2 individual TP sensors within the throttle body assembly.
The TP sensors are used to determine the throttle plate angle. The TP sensors provide the powertrain control module (PCM) with a signal voltage proportional to throttle plate movement. Both TP sensor signal voltages are low at closed throttle and increase as the throttle opens.