LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Carefully clean the throttle body mounting surfaces of any gasket and/or seal material.
    2. Fig 1: View Of Throttle Body
    GM1285255Courtesy of GENERAL MOTORS CORP.
  2. Install the throttle body and NEW gasket.
    3. NOTE: Refer to Fastener Notice .
  3. Install the throttle body bolts.

    Tighten:  Tighten the throttle body bolts to 10 N.m (89 lb in).

    4. Fig 2: View Of Wiring Harness Conduit
    GM1285256Courtesy of GENERAL MOTORS CORP.
  4. Install the wiring harness conduit.
    5. Fig 3: View Of Throttle Body Electrical Connector
    GM945417Courtesy of GENERAL MOTORS CORP.
  5. Install the throttle body electrical connector.
  6. Install the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement .
scientia non olet · About LEMON Manuals