LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Intake Manifold Runner Control Solenoid Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Intake Manifold Runner Control Solenoid
    GM1285195Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: DO NOT separate the upper intake manifold from the lower intake manifold.
  1. Remove the upper intake manifold. Refer to Upper Intake Manifold Replacement .
  2. Remove the intake manifold runner control solenoid bolts.
  3. Remove the intake manifold runner control solenoid.
scientia non olet · About LEMON Manuals