LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Intake Manifold Runner Control Solenoid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Intake Manifold Runner Control Solenoid
    GM1285195Courtesy of GENERAL MOTORS CORP.
  1. Install the intake manifold runner control solenoid.
    2. NOTE: Refer to Fastener Notice .
  2. Install the intake manifold runner control solenoid bolts.

    Tighten:  Tighten the intake manifold runner control solenoid bolts to 10 N.m (89 lb in).

  3. Install the upper intake manifold. Refer to Upper Intake Manifold Replacement .
scientia non olet · About LEMON Manuals